Print Page - What posi manufacturers could have been used in a Norwood 1969 Camaro?

Title: What posi manufacturers could have been used in a Norwood 1969 Camaro?
Post by: LeadFoot_69_Z/28 on August 09, 2007, 05:39:02 PM

From a crg REPORT on 1967 - 1969 Camaro Axles:
When a 1967 - 1969 Camaro was equiped with a posi rear axle, it would be stamped on the second line with a letter which was the positraction manufacturer code. The posi manufacturer codes are D for Dana, E for Eaton, and W for Warner.

Could a Norwood 1969 Z28 have an axle made by Dana, Eaton, or Warner?

Thank you in advance for your input...

Title: Re: What posi manufacturers could have been used in a Norwood 1969 Camaro?
Post by: JohnKY on August 10, 2007, 05:16:44 AM

I'm not aware of anything other than Eaton being used in passenger car axles. Dana and Warner were used in trucks, I believe.

Title: Re: What posi manufacturers could have been used in a Norwood 1969 Camaro?
Post by: JohnZ on August 10, 2007, 11:47:53 AM

All Camaro positraction axles used Eaton ("E") posi units.

Title: Re: What posi manufacturers could have been used in a Norwood 1969 Camaro?
Post by: LeadFoot_69_Z/28 on August 11, 2007, 09:01:00 AM

Thanks for the information.

Now all I need to do is find one for a 1969 April 3rd week Z...

CRG Discussion Forum

Camaro Research Group Discussion => Decoding/Numbers => Topic started by: LeadFoot_69_Z/28 on August 09, 2007, 05:39:02 PM