Does anyone know what angle in degrees the original tail pipe ends were cut on for assembly line installed pipes? Picture shows an original exhaust tail pipe.
That's my car. :) 30 degrees.....Joe
Just two weeks ago a friend of mine had a similar curiosity and what he did was put a small carpenters magnetic level on top of the tail pipe extension to level it horizontally then used his iPhone with a level app installed and placed it against the end cut to get the angle reading. I don't recall what it was though but the idea was clever.
Mike
I used a dial measure like for a pinion. Somebody else ask about that a while back. Those are my original pipes in that picture...Joe
Thanks Joe. :)
Sliding angle finder.