Text only | Text with Images

CRG Discussion Forum

Camaro Research Group Discussion => Originality => Topic started by: x66 714 on February 23, 2020, 11:44:46 AM

Title: 1968 302 lower plug wire looms
Post by: x66 714 on February 23, 2020, 11:44:46 AM
Does a 1968 302 use the lower plug wire looms with 2 slots or 3? Thank you, Joe
Title: Re: 1968 302 lower plug wire looms
Post by: janobyte on February 23, 2020, 01:02:41 PM
UPC 6
B5

3, assuming you mean on the valve covers,,3 slot dividers prior to the upper loom brackets.
Title: Re: 1968 302 lower plug wire looms
Post by: x66 714 on February 23, 2020, 02:12:54 PM
So the one on the left is correct? Do you know what the on the right is for? Thank you, Joe
Title: Re: 1968 302 lower plug wire looms
Post by: janobyte on February 23, 2020, 02:36:49 PM
At some point I remember a thread about use of 2 vs. 3.   I just went off the assembly manual. Are those survivors off your car? Mines a Norwood build, if that means anything.
Title: Re: 1968 302 lower plug wire looms
Post by: x66 714 on February 23, 2020, 03:29:12 PM
Since it was supplied with the engine, it shouldn't matter if Norwood or LA. Mine is LA. Was just looking through parts & thought I would find out for sure. I'm not sure where the 2 wire ones came from. The 3 wire ones I purchased from Chevrolet in about 1977.

What do you have on your engine?...Joe
Title: Re: 1968 302 lower plug wire looms
Post by: janobyte on February 23, 2020, 03:54:54 PM
I put 3 both sides, came as a set, stamped, bk off the top of my head,I think.
Title: Re: 1968 302 lower plug wire looms
Post by: janobyte on February 23, 2020, 03:56:32 PM
Not original to the car, aftermarket.
Text only | Text with Images