Print Page - Defogger switch

Title: Defogger switch
Post by: camaroman1969 on December 04, 2017, 09:03:24 PM

I would like to install a "defogger blower" on my 1969 Camaro SS/RS. Question: Does one have to cut dash, or is this already pre-cut behind the wood grain covering?? All comments will be appreciated. Thanks guys! Don

Title: Re: Defogger switch
Post by: william on December 04, 2017, 09:43:33 PM

Not pre-cut. The woodgrain trim was pre-punched for the switch if the car was ordered with a defogger. Dimensions for the dash are shown in Section C50 page A1 of the Assembly Instruction Manual.

Title: Re: Defogger switch
Post by: camaroman1969 on December 04, 2017, 11:25:46 PM

Thanks Bill. Doesn't look like its gonna be a easy task to install this defogger.

Title: Re: Defogger switch
Post by: camaronut on December 05, 2017, 07:11:00 PM

Nothing a dremel tool can't handle. Been there, done that.

Title: Re: Defogger switch
Post by: Boston14 on December 09, 2017, 07:21:39 PM

I believe the woodgrain trim for a convertible with power top is the same.

Title: Re: Defogger switch
Post by: Charley on December 09, 2017, 09:28:21 PM

There was also double bezel for convert top and rear window defog

Title: Re: Defogger switch
Post by: camaroman1969 on December 20, 2017, 06:58:30 PM

Thanks guys for all your input. This will help.

CRG Discussion Forum

Camaro Research Group Discussion => General Discussion => Topic started by: camaroman1969 on December 04, 2017, 09:03:24 PM