Does anyone have photos, or tell me where I can find them, of the correct screws that attach the bracket where the heater hoses goes into the firewall through the cover?
Thank you,
Jody
Jody, going by your previous posts you have a 69, correct? If so, the bracket screws (number 10 in the drawing below) are P/N 9419321 and you can get them from AMK (http://amkproducts.com/Catalog_PDF.htm).
Ed
Yes, I have a 1969 Camaro with a big block. Thanks for helping. Someone replaced mine with regular screws.
Jody
Here are mine, before and after. Sorry they aren't closer...
(https://c1.staticflickr.com/1/672/32425708122_188bbc5580.jpg) (https://flic.kr/p/Rpmek9)
(https://c1.staticflickr.com/1/346/32199588280_e133ce3d9d.jpg) (https://flic.kr/p/R4niMb)
I believe these are the same if I remember right:
(https://c1.staticflickr.com/1/582/32425837492_4b79ff5a97.jpg) (https://flic.kr/p/RpmTME)
Same 9419321 screw is used to fasten the dimmer switch to the floor pan.
Quote from: william on March 14, 2017, 12:21:10 PM
Same 9419321 screw is used to fasten the dimmer switch to the floor pan.
Are you sure William? They seem awfully short for that. I have one original dimmer switch screw for my 69 and I was looking for the second one.
QuoteAre you sure William? They seem awfully short for that. I have one original dimmer switch screw for my 69 and I was looking for the second one.
Yep. Dave, take a look at your AIM, UPC 12, Sheet B6, item 1 and you'll see it's the same screw.
That screw was used in a TON of places on multiple models and multiple GM divisions, so it's fairly common.
Ed
Quote from: bertfam on March 14, 2017, 02:25:55 PM
QuoteAre you sure William? They seem awfully short for that. I have one original dimmer switch screw for my 69 and I was looking for the second one.
Yep. Dave, take a look at your AIM, UPC 12, Sheet B6, item 1 and you'll see it's the same screw.
That screw was used in a TON of places on multiple models and multiple GM divisions, so it's fairly common.
Ed
Well alrighty then. I'll take a look. Thanks.