CRG Discussion Forum
Welcome, Guest. Please login or register.
Did you miss your activation email?
July 30, 2014, 10:16:24 AM

Login with username, password and session length
Search:     Advanced search
Welcome to the CRG Discussion Forum!
Forum registration problems: Make sure you enter your email correctly and you check your spam box first. *Then* email KurtS2@gmail for help.
102488 Posts in 12091 Topics by 4669 Members
Latest Member: paulmanta
* Home Help Search Login Register
+  CRG Discussion Forum
|-+  Camaro Research Group Discussion
| |-+  Maintenance
| | |-+  '69 blower fan replacement
« previous next »
Pages: [1] Print
Author Topic: '69 blower fan replacement  (Read 1090 times)
Springer Tom
Member
***
Posts: 39


View Profile Email
« on: August 21, 2012, 08:13:26 PM »

Could someone tell me the simple way to replace the blower fan? My car was painted and the front end put on without the A/C box and blower fan installed. Chassis manual says pull lower fender out 6"!!!! after loosening the rear skirt bolts. Don't mind spending the time but didn't want to take the fender off unless I had to......thanks guys
Logged
tmodel66
Hero Member
*****
Posts: 1212


View Profile Email
« Reply #1 on: August 21, 2012, 09:14:26 PM »

In the long run you will be way ahead of the game to just go ahead and pull the fender. It's a fight from the word go if you don't.
Logged

Daniel  
'69 SS 350/4 speed  Fathom Green--POP
joesauer
Member
***
Posts: 136


View Profile
« Reply #2 on: August 22, 2012, 11:21:47 AM »

Ditto.  Been through this twice....much less risk of paint/body damage if you carefully remove the fender vs wedge it out & brace lower portion with a 2 x 4.  Just mark all the bolt & alignment points for easier reinstallation.
Logged
KevinW
Member
***
Posts: 406


View Profile Email
« Reply #3 on: August 22, 2012, 03:26:27 PM »

X3, my car was back from paint for 3 weeks when I had to take the fender off to get to the heater box.  Ended up getting a much better panel alignment after I got it back together Smiley 
Logged
Stingr69
Member
***
Posts: 394


View Profile Email
« Reply #4 on: August 24, 2012, 10:35:19 AM »

It is easier than it sounds. Loosten the 2 fasteners on the fender bottom, pull out the inner wheel well screws and swing the fender away from the car. Block it with a piece of wood.

-Mark.
Logged
Springer Tom
Member
***
Posts: 39


View Profile Email
« Reply #5 on: September 02, 2012, 08:25:30 PM »

Yeah, pulled the fender and skirt, etc. wasn't too bad, had it all apart in about 45 minutes,thanks fellas
Logged
Pages: [1] Print 
« previous next »
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.19 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!
Page created in 0.074 seconds with 18 queries.