Author Topic: reproduced sheetmetal  (Read 2586 times)


  • Member
  • ***
  • Posts: 29
    • View Profile
reproduced sheetmetal
« on: June 16, 2006, 02:10:03 AM »
I know this topic has been covered recently on this forum but please bear with me, I'm not sure the question was answered previously. I'm to the point of needing to make a decision about front fenders on a Z-10 project. Who makes the "best" repo front fenders for a '69 Camaro, Goodmark or Dynacorn?

Any other manufacturers other than these? Are the fenders from Ricks, NPD, Original Parts Group, Camaro Central, etc all supplied by one of these two manufacturers?

Thanks in advance for any guidance you can give...


  • Newbie
  • *
  • Posts: 17
    • View Profile
Re: reproduced sheetmetal
« Reply #1 on: June 17, 2006, 12:32:56 PM »
Hey Danz10
I asked a similar ? in the General Discussion group and got a response that may help...
I wonder the same things about sheetmetal, as you do... good luck with your project...