CRG Discussion Forum
Welcome, Guest. Please login or register.
Did you miss your activation email?
April 24, 2015, 07:27:57 PM

Login with username, password and session length
Search:     Advanced search
Welcome to the CRG Discussion Forum!
Forum registration problems: Make sure you enter your email correctly and you check your spam box first. *Then* email KurtS2@gmail for help.
112256 Posts in 12898 Topics by 4935 Members
Latest Member: rspallina
* Home Help Search Login Register
+  CRG Discussion Forum
|-+  Camaro Research Group Discussion
| |-+  Maintenance
| | |-+  Right turn signal bulb in dash.
« previous next »
Pages: [1] Print
Author Topic: Right turn signal bulb in dash.  (Read 812 times)
Posts: 6

View Profile
« on: July 05, 2011, 10:06:21 AM »

 On a 1968 convertible, what is the best method to replace the right turn signal bulb in the dash board? I removed all the screws in the panel holding the speedometer and fuel gauge. This panel doesn't seem to pull out far enough to get at the bulb without disconnecting the harnesses and speedometer cable on the back side which I don't want to do unless absolutely necessary. 
 Am I making this a bigger job than necessary or is there a way of getting to it from the back side?
Posts: 151

View Profile
« Reply #1 on: July 05, 2011, 12:42:16 PM »

Think you are making it too complicated.  When mine needed replacing, I reached under & behind the instrument cluster, & just twisted the lamp socket until it disengaged.  Pulled it out, stuck a new bulb in the socket, an reinstalled (by twisting).
Hero Member
Posts: 1629

View Profile Email
« Reply #2 on: August 25, 2011, 05:21:32 PM »

You don't want to pull out the pod.  Do like JS said, reach in behind.  To pull out the pod you have to lower the steering column and loosen and unhook a lot of stuff.

Pages: [1] Print 
« previous next »
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.20 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!
Page created in 0.07 seconds with 17 queries.