Author Topic: correct heater hose routing  (Read 4841 times)

68rs327conv

  • Member
  • ***
  • Posts: 111
    • View Profile
    • The build
Re: correct heater hose routing
« Reply #15 on: December 06, 2010, 01:04:01 AM »

Is the AIM always truly "correct"? Also kinda stumped on this a/c inner fender clip. Mine doesn't have one, nor is there any evidence that one ever was there. I have all the original sheetmetal too!  

On D4 page 214 it shows clamp 3925746, and clip 3827770 for the compressor hoses just about the heater hose clamp.  Has anyone seen this on a 68 AC car?

Mike

Mike
68 RS Conv 327/210hp, Powerglide Factory AC

big iron

  • Hero Member
  • *****
  • Posts: 586
    • View Profile
Re: correct heater hose routing
« Reply #16 on: December 06, 2010, 03:11:10 AM »

Is the AIM always truly "correct"? Also kinda stumped on this a/c inner fender clip. Mine doesn't have one, nor is there any evidence that one ever was there. I have all the original sheetmetal too! 


On D4 page 214 it shows clamp 3925746, and clip 3827770 for the compressor hoses just about the heater hose clamp.  Has anyone seen this on a 68 AC car?

Mike



Has anyone seen this on a 68 BB AC car?
Bob

lakeholme

  • Hero Member
  • *****
  • Posts: 2257
  • 68-12D L30/M35
    • View Profile
Re: correct heater hose routing
« Reply #17 on: December 10, 2010, 10:03:49 PM »
How about where the fender comes down to the inner fender? There are two holes there that are not on the driver's side. Think that might be where the a/c hose was clamped? If it was? Looks too far back to me.
Phillip, HNR-AACA, Senior Master, Team Captain
Charlotte Autofair, Sept 24-27, 2015
Southeastern Spring Meet Chair, April 9, 2016
Sentimental Tour Host, June 12-17, 2016