CRG Discussion Forum
Welcome, Guest. Please login or register.
Did you miss your activation email?
November 21, 2014, 03:37:49 PM

Login with username, password and session length
Search:     Advanced search
Welcome to the CRG Discussion Forum!
Forum registration problems: Make sure you enter your email correctly and you check your spam box first. *Then* email KurtS2@gmail for help.
106445 Posts in 12409 Topics by 4785 Members
Latest Member: Bolaro 67 SS350
* Home Help Search Login Register
+  CRG Discussion Forum
|-+  Camaro Research Group Discussion
| |-+  Restoration
| | |-+  Door edge guards installation
« previous next »
Pages: [1] Print
Author Topic: Door edge guards installation  (Read 1808 times)
My68SS
Member
***
Posts: 342



View Profile
« on: May 09, 2006, 11:01:01 AM »

Hi all, How does one go about fitting the bright metal door edge guards without chipping the paint anyway! [68 Camaro]
They seem a tight fit. The shop manual doesn't give any clues.
Logged

Rob
1968 L34/M40 SS
12 bolt posi 3.55
Build - 12C
JohnZ
CRG Member
*****
Posts: 4141


View Profile Email
« Reply #1 on: May 09, 2006, 01:45:49 PM »

The plants put them on with a rubber hammer, and weren't concerned about chips that were hidden under the moldings (which is why I haven't touched the ones that are on my original '69).
Logged

'69 Z/28
Fathom Green
CRG
RickH
Member
***
Posts: 105


View Profile Email
« Reply #2 on: May 12, 2006, 09:14:33 AM »

If you are using repop or other then original make sure you fit them before paint. Also if you repaint over old paint the edges may be a little thicker and the paint will chip and roll forward leaving a small ridge down rthe length of the edge guards. . I have seen this happen and it wasn't pretty. If you go to bare metal and use the original guards they should fit as before. My car was taken down to bare metal and my guards fit on with no problem after repaint. No chips show.

Good liuck

Rick H.
Logged
Pages: [1] Print 
« previous next »
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.20 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!
Page created in 0.082 seconds with 18 queries.