Camaro Research Group Discussion > Originality
Chambered exhaust hanger
fireZ:
Anyone have a good picture of the exhaust hanger that supports the chambered pipe just before it goes up and over the rear axle. Not sure were this hanger bolts to the car. Thanks
BlackoutSteve:
I would think it's the same mount location as the N10 dual exhaust hangers.
I don't think there are any other locations in that area.
IZRSSS:
You can find the information in AIM NC8-A1 thru NC8-A3.
Stingr69:
The GM hangar looks like this. It uses basically a large sheet metal screw attached to the bottom of the car and is clamped to the pipe on the other end.:
-Mark.
IZRSSS:
Can anyone tell me if the chambered exhaust was an option for the L48 or was it strictly for the big block cars? Also, when was this option available during the '69 run. Its my understanding it was latter in the year...is this correct?
Navigation
[0] Message Index
[#] Next page