67 power feed wire

[big iron]

Anyone have a picture of the firewall piercing for the 67 power feed wire A31/C06?
Bob

[big iron]

 Correction that should be power lead not power feed.
Bob

Anyone have a picture of the firewall piercing for the 67 power feed wire A31/C06?
Bob

[JohnZ]

A31 didn't have a firewall piercing - it was fed from the fuse block.

[x66 714]

Unless 67 is different the 68/69 for power windows and/or power top there should be a wire going through the firewall. There's a wire (black) that comes from the horn relay & goes to the circuit breaker that's attached to the firewall behind the m/c power booster. The wire coming from the circuit breaker (orange w/blk) goes through the firewall. It has a small grommet attached to it. There's a dimple in the firewall where you would need to drill. It's discussed in the assm manual. If I'm not mistaken it's near the upper LH bolt for the pedal mount. I can look tonight if that would help....Joe

[x66 714]

I gave you the wrong info. The wire going through the firewall is next to a ground strap below the wiper motor....Sorry.
Joe

[big iron]

Sorry for the delay and thanks for the responce.
JohnZ, you are correct in that the window relay coil (A31) was fed from the fuse box but the window motors where feed from the circuit breaker(C06) on the firewall.

A31 didn't have a firewall piercing - it was fed from the fuse block.

Joe, the power lead wire is different for 69 than for 67,68. Are you sure that your original reply was not correct?
Bob

[big iron]

No 67's with electric windows or convertibles w/ power top?
Bob

[x66 714]

MY first reply was mostly correct except fot the placement of the hole for the wire that goes through the firewall , at least for 68/69. I don't have an assm manual for a 67 to check. C06 show the harness placement & A31 say to refer to C06....Joe