Author Topic: embarrassing question but here goes....  (Read 1038 times)

The Patch

  • Newbie
  • *
  • Posts: 1
    • View Profile
embarrassing question but here goes....
« on: October 27, 2010, 11:38:22 PM »
I'm disassembling my '69 project and I've been searching for hours thru the '69 AIM. I cannot find where the screws and molding designations are that Wilbur the Wildcat is pointing to.  :-[

This is important because I am cataloging and labeling all the nuts, bolts, pieces etc. exactly as they are wrjtten in the AIM. To be consistent, I'd rather not write a verbal description of the pieces. If anyone can point me to the proper page where these things are located I'd be grateful.

Thanks!



flyingskibiker

  • Member
  • ***
  • Posts: 310
    • View Profile
Re: embarrassing question but here goes....
« Reply #1 on: October 28, 2010, 12:07:49 AM »
That information is in the Body by Fisher service manual.  But they don't really give any screw data, just that screws are used to hold on #3 in the picture ('68)...