Author Topic: 69 clock bulb  (Read 2212 times)

69z28302

  • Member
  • ***
  • Posts: 388
    • View Profile
69 clock bulb
« on: March 21, 2011, 12:18:29 AM »
I just got my clock back from being repaired. Went to put it in and the bulb socket wont fit. I have the blade type bulb in it that is oblong and it seems to bottom out. What bulb does it take? Rick's shows a console bulb but mine has a connector with the "push in" not twist bulb. 

Thanks CRG
Mike

Gramps69Z

  • Hero Member
  • *****
  • Posts: 650
  • 69 X33 D80
    • View Profile
Captain John Wykoff
Destin Fire:   October 31, 2015 at 0700--Officially Retired

69z28302

  • Member
  • ***
  • Posts: 388
    • View Profile
Re: 69 clock bulb
« Reply #2 on: March 21, 2011, 01:29:46 AM »
That looks like what I have now. The socket just wont fit in the clock though. It's like it's too long



Thanks

Mike



IZRSSS

  • Guest
Re: 69 clock bulb
« Reply #3 on: March 21, 2011, 01:45:00 AM »
The AIM indicates part# 9425542 {bulb}...you must also have the correct Wire Assembly/Socket; part# 6297523 {note; the adjustment knob is a part of the wire ASM}

69z28302

  • Member
  • ***
  • Posts: 388
    • View Profile
Re: 69 clock bulb
« Reply #4 on: March 21, 2011, 02:03:56 AM »
I'll check it again tomorrow.

Thanks

IZRSSS

  • Guest
Re: 69 clock bulb
« Reply #5 on: March 21, 2011, 02:16:35 AM »
Here's the AIM sheet...

69z28302

  • Member
  • ***
  • Posts: 388
    • View Profile
Re: 69 clock bulb
« Reply #6 on: March 22, 2011, 12:52:22 AM »
Looks like the clock base itself has been hot and is slight concave in it. I"ll have to figure out something to make the socket stay in the housing