Author Topic: VINYL TOP MOLDINGS??  (Read 9189 times)

GS438

  • Newbie
  • *
  • Posts: 2
    • View Profile
VINYL TOP MOLDINGS??
« on: October 28, 2005, 11:30:04 PM »
Can anyone tell me where to get vinyl top moldings for my 69 ? Also is there a template to install the hardware in the right location

guinns-engineering

  • Newbie
  • *
  • Posts: 5
  • Camaro Documentation and Cross Ram Services
    • View Profile
    • Guinns Engineering
Re: VINYL TOP MOLDINGS??
« Reply #1 on: November 26, 2005, 05:24:24 AM »
I have a few excellent used sets. Please contact me by email at wguinn@ptd.net or
Guinns-Engineering.com

« Last Edit: November 26, 2005, 05:26:22 AM by guinns-engineering »
Guinns Engineering
Three Bridges NJ

CNorton

  • Member
  • ***
  • Posts: 213
    • View Profile
Re: VINYL TOP MOLDINGS??
« Reply #2 on: November 26, 2005, 01:46:16 PM »
I also have an excellent used set (just in case you happen to live closer to the west coast).

c

chuck69ss

  • Newbie
  • *
  • Posts: 2
    • View Profile
    • Home page
Re: VINYL TOP MOLDINGS??
« Reply #3 on: November 29, 2005, 03:58:50 PM »
I haven't seen a template but once you have a used set of trim, you should be able to lay it out on the car, make it symetrical, and figure out where to attach it.  There are a few pics of the mounting holes and studs in my pics.

http://chuckbro.smugmug.com/gallery/612251

Chuck B
69 Camaro SS Clone - owned 20+ years, finally getting into the restoration.
http://hobbystage.net/camaro/chuck69ss/
http://chuckbro.smugmug.com/Cars

nuch_ss396

  • Member
  • ***
  • Posts: 265
    • View Profile
Re: VINYL TOP MOLDINGS??
« Reply #4 on: December 11, 2005, 06:41:57 AM »
I have a few excellent used sets. Please contact me by email at wguinn@ptd.net or
Guinns-Engineering.com



Hi Wayne,

I have a fast question for you while we are on this topic.  I remember reading somewhere that the 69 vinyl top molding
was also used when two-tone paint was ordered.  But, the molding did not have the center recessed area painted.
Is that true?  Also, were all the moldings painted black in this recessed area, or were other paint colors used?

Steve
69 SS 396, Hugger Orange, D/80, D/90
Chambered Exhaust, N/66, THM400, 3:73 posi

Steve A.
  CRG

KurtS

  • CRG Coordinator
  • *****
  • Posts: 5881
    • View Profile
Re: VINYL TOP MOLDINGS??
« Reply #5 on: December 12, 2005, 06:01:25 AM »
I believe I (or William) posted that.
The trim has different part #'s. That's the only known difference.
Only black in the recess.
Kurt S
CRG

 

anything