CRG Discussion Forum
Welcome, Guest. Please login or register.
Did you miss your activation email?
October 31, 2014, 01:04:13 PM

Login with username, password and session length
Search:     Advanced search
Welcome to the CRG Discussion Forum!
Forum registration problems: Make sure you enter your email correctly and you check your spam box first. *Then* email KurtS2@gmail for help.
105862 Posts in 12354 Topics by 4762 Members
Latest Member: HarryQ
* Home Help Search Login Register
+  CRG Discussion Forum
|-+  Camaro Research Group Discussion
| |-+  Restoration
| | |-+  pointers for new hinges
« previous next »
Pages: [1] Print
Author Topic: pointers for new hinges  (Read 1472 times)
william1
Member
***
Posts: 43


View Profile
« on: August 21, 2009, 09:04:08 AM »

 OK after a search i gonna ask,, any pointers,, short cuts, to lining up camaro doors after installing new hinges.
Logged
JohnZ
CRG Member
*****
Posts: 4126


View Profile Email
« Reply #1 on: August 21, 2009, 09:36:53 AM »

Fit them fore-aft to the quarters, and up-down and in-out to the rockers; fore-aft and up-down is at the pillar side, in-out is at the door side. Remove the striker bolts first, fit the doors, then install the strikers last to set in-out at the rear of the door and smooth closing effort.
Logged

'69 Z/28
Fathom Green
CRG
mark x22
Member
***
Posts: 131


View Profile
« Reply #2 on: August 21, 2009, 03:44:26 PM »

If the door panels are off you can adjust the striker bolt from inside the door with the door closed through an access hole in the door latch .
Logged
1968RSZ28
Hero Member
*****
Posts: 4785



View Profile
« Reply #3 on: August 21, 2009, 06:53:37 PM »

There's tons of information for you on this subject in Section 6 of the 1969 Body by Fisher Service Manual.

Paul
Logged
william1
Member
***
Posts: 43


View Profile
« Reply #4 on: August 25, 2009, 07:13:43 AM »

 thanks ,, will try and yes have fisher manuel coming,
Logged
Pages: [1] Print 
« previous next »
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.19 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!
Page created in 0.083 seconds with 17 queries.