Author Topic: Competition plus rods  (Read 4376 times)

vtfb68

  • Hero Member
  • *****
  • Posts: 527
    • View Profile
Competition plus rods
« on: March 14, 2009, 04:42:27 AM »
Hi all,
Does anyone know or know where I can find the Correct part number  or rod numbers for a competition plus shifter? They may be in a bucket with about 20 others.  I will be using this to replace a muncie shifter (factory warranty replacement anyway) in a Stock BB car with a console and was wondering if anybody has any "heads up" on this. Also, does anyone have a picture of a Muncie stick stamped "MUNCIE" that they can post?  as this will be mated to the shifter.
 Thanks for reading and good luck on all your projects,
      Victor
68 05C LA RS/SS U2 712 L34 M21 BR
68 08E LA RS Y2 749 L30 M35
67 11B LA  RS/SS M-1 797-Z L48 M21  Convertible

JohnZ

  • CRG Member
  • *****
  • Posts: 4365
    • View Profile
Re: Competition plus rods
« Reply #1 on: March 15, 2009, 02:53:06 PM »
Here's a Muncie linkage photo; '67-'68, I think.
'69 Z/28
Fathom Green
CRG

ss jim

  • Member
  • ***
  • Posts: 88
    • View Profile
Re: Competition plus rods
« Reply #2 on: March 15, 2009, 04:19:47 PM »
P/N for Hurst shifter w/stick is 391-4339 shifter w/o stick is 391-4340; 1-2 rod is 213-5307; 3-4 is 213-2145; rev is 213-3691. P/N for complete kit (shifter and installation kit) is 291-6561. This is for 67-68 Camaro with or with out console. Hope this helps. Jim

Pex68

  • Member
  • ***
  • Posts: 394
    • View Profile
Re: Competition plus rods
« Reply #3 on: March 17, 2009, 01:51:00 AM »
The handle on a Muncie shifter is part of the shifter itself, you'll have to cut the handle and drill 2 holes for it to mate up with a Hurst body, and add a slight bend to it for it look right.  Those handles are seriously hardened, good luck with the drilling of the holes-you need carbide tipped bits.  Been there done that!
Chris P
1968 Sequoia Green SS 396/325 M20

vtfb68

  • Hero Member
  • *****
  • Posts: 527
    • View Profile
Re: Competition plus rods
« Reply #4 on: March 19, 2009, 01:14:28 AM »
 Hi Guys,
Thanks for the replys. Out of 23 rods not  single match, though the shifter and levers are correct. I will check the Long beach Hi-perf swap meet on Sunday, I may get lucky. Thanks again for the Info, picture, and advice.
  Victor
68 05C LA RS/SS U2 712 L34 M21 BR
68 08E LA RS Y2 749 L30 M35
67 11B LA  RS/SS M-1 797-Z L48 M21  Convertible