« previous next »
Pages: [1]

Author Topic: Rear spoler installation and sealing  (Read 3196 times)

GaryL

  • Hero Member
  • *****
  • Posts: 538
  • Marilyn and me
    • View Profile
Rear spoler installation and sealing
« on: March 17, 2008, 11:11:34 PM »
What is the best method to seal the spoiler installtion? Rubber washers under the nuts? Strip caulk?
Logged
Gary

Lemans Blue X33. DZ, M20, manual steering. Only BU code rear end is original.

Jonesy

  • Member
  • ***
  • Posts: 458
  • 1969 Camaro z28
    • View Profile
Re: Rear spoler installation and sealing
« Reply #1 on: March 21, 2008, 03:03:04 PM »
Gary

I used strip caulk and dum dum or electrical sealing putty and have no problems.

I did not used rubber washers, just the factory setup.
Logged
1967 RS-Z/28 Nantucket Blue the D-2 car
1969 RS/SS 350 4 speed Azure Turquoise
1969 Z28 Azure Turquoise

GaryL

  • Hero Member
  • *****
  • Posts: 538
  • Marilyn and me
    • View Profile
Re: Rear spoler installation and sealing
« Reply #2 on: March 21, 2008, 03:13:23 PM »
I put strip caulk under soft rubber washers on the front studs. Then a good amount of strip caulk on the front nut/washer to plug the hole from underneath. Nothing on the rear acorn nuts. I also used aluminum duct tape to cobver the emblem holes. Seems to be working after my water test.
Logged
Gary

Lemans Blue X33. DZ, M20, manual steering. Only BU code rear end is original.
Pages: [1]
« previous next »
 

anything