CRG Discussion Forum
Welcome, Guest. Please login or register.
Did you miss your activation email?
September 21, 2014, 03:10:55 AM

Login with username, password and session length
Search:     Advanced search
Welcome to the CRG Discussion Forum!
Forum registration problems: Make sure you enter your email correctly and you check your spam box first. *Then* email KurtS2@gmail for help.
104616 Posts in 12242 Topics by 4719 Members
Latest Member: Baconcks
* Home Help Search Login Register
+  CRG Discussion Forum
|-+  Camaro Research Group Discussion
| |-+  Decoding/Numbers
| | |-+  Rear axel posi designation
« previous next »
Pages: [1] Print
Author Topic: Rear axel posi designation  (Read 2002 times)
ccargo
Member
***
Posts: 236


View Profile Email
« on: December 28, 2005, 03:26:42 PM »

I have a very clean QW 0330 G2 rear axel in my 67 L35. It does have the radius braket and bar installed. What I dont see anywhere is the posi designation "E" under the assembly code  Huh I was wondering if the bracket was installed prior to the assembly code being stamped and also was the posi designation stamped at the same time as the assembly code. Kinda "what came first, the chicken or the egg"  Wink Would it be unusual to not have a posi designation on a posi axel? No damage or rust issues to obscure the stamp....its just not there.
Logged
Z71
Member
***
Posts: 80


View Profile WWW Email
« Reply #1 on: December 28, 2005, 04:18:41 PM »

All the stamped codes were done at the axle plant, not the final assembly plant.

If you do not have an "E" under the first part of the axle code, it was not a posi when it left the plant, someone must have added that later. 
Logged

Mike
Owned new (and still have stashed away) LOL
1966 Impala SS396
1970 Chevelle SS454
1972 El Camino SS350
1973 Chevelle SS350
2002 Trans Am WS6 Ram Air
KurtS
CRG Coordinator
*****
Posts: 3209


View Profile Email
« Reply #2 on: December 28, 2005, 11:02:39 PM »

QW is a posi code though. So it would appear that they missed stamping it.
Logged

Kurt S
CRG
ccargo
Member
***
Posts: 236


View Profile Email
« Reply #3 on: December 28, 2005, 11:25:54 PM »

Any chance the bracket would have been welded on over it?
Logged
dews 67
Newbie
*
Posts: 10


View Profile Email
« Reply #4 on: December 29, 2005, 09:30:12 PM »

I dont have the e stamped on my 67 either.  Its a posi also. Enough room between the stamping and the radius bar bracket.  Nothing..
Logged
Pages: [1] Print 
« previous next »
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.19 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!
Page created in 0.142 seconds with 18 queries.