How well to the 69 reproduction wheel well moldings fit?

[KevinW]

Steve, OK, I have 2 sets of extra rears.  One set should be able to be cleaned and polished to get close to match the NOS ones you bought.  The 2nd set is straight and good on the outside, but the inner edges show some wear (stones?)  the inner edge where it screws in has 1/8 in deep wear.  Hard to explain.  Ideally, I would like to get a set of good original fronts so I can sell one good full set of originals.   But we can talk.     

[sdkar]

What do you need to part with the nicer of them?  All I need is the passenger rear.  I have an extra driver rear GM brand new still in the wrapper if you want to make that part of the deal.

[KevinW]

Steve, I was hoping to put together a full set to sell from my extras, but another drivers side rear would give me 3 of them, too many.  Do you have an extra driver front? 

[sdkar]

I don't have an extra driver front but I believe that the dealer in my area may have a new GM front driver I can get from him.

Steve

email me directly
sdkar@bellsouth.net

[Jonesy]

The 2 front are still available from GM. I bought some about 6 months ago. I am not sure how they compare to the older NOS.

[Hylton]

I just put full Goodmark quarters on my '69 and the GM mouldings fit perfectly! I could not believe how well they fit actually.