« previous next »
Pages: [1]

Author Topic: 67 taillamp bezel screws  (Read 3606 times)

Ron C.

  • Member
  • ***
  • Posts: 448
    • View Profile
67 taillamp bezel screws
« on: June 02, 2007, 05:42:53 PM »
the screws that hold the back plate over the lenses are ther phillips or hex head screws? when these screws are removed you can take the cover off to access the lenses.
Logged
67Z/28,67RSZ/28,71SS454CHEVELLE.

1968RSZ28

  • Hero Member
  • *****
  • Posts: 6188
    • View Profile
Re: 67 taillamp bezel screws
« Reply #1 on: June 03, 2007, 02:20:07 AM »
Ron -

These fasteners on my '68 Z/28 are all hex head screws.  They all have a big G (for Guide?) with a smaller L (for lamp?) inside the G on the heads of the fasteners.  

Paul
Logged

Ron C.

  • Member
  • ***
  • Posts: 448
    • View Profile
Re: 67 taillamp bezel screws
« Reply #2 on: June 03, 2007, 02:32:41 AM »
I will get a pic tomorrow.
Logged
67Z/28,67RSZ/28,71SS454CHEVELLE.

Jerry@CHP

  • CRG Member
  • *****
  • Posts: 1512
    • View Profile
Re: 67 taillamp bezel screws
« Reply #3 on: June 03, 2007, 01:37:35 PM »
Ron,

My survivor car one of each, phillips and the other hex.  Either is correct for your car but do both the same so they match.  Don't duplicate factory defects.

Jerry
Logged

Ron C.

  • Member
  • ***
  • Posts: 448
    • View Profile
Re: 67 taillamp bezel screws
« Reply #4 on: June 03, 2007, 05:37:10 PM »
Jerry you wont beleive this but mine also has both! On mine the right hand side has phillips and the left has hex head screws! maybe the right side assembly worker ran outta hex head screws ???
Logged
67Z/28,67RSZ/28,71SS454CHEVELLE.
Pages: [1]
« previous next »
 

anything