Author Topic: Correct 68 RS lower belt trim hole placement  (Read 5744 times)

70L34

  • Member
  • ***
  • Posts: 172
    • View Profile
Correct 68 RS lower belt trim hole placement
« on: September 02, 2018, 01:48:34 AM »
Hi folks,

I bought a nice 68 that has NOS quarters and fenders and was never finished. It came with all the NOS trim and clips and now I’d like to drill the holes properly. Does anyone have a source for the templates, or should I just follow the AIM?

Thanks,
Tony

Jon Mello

  • CRG Member
  • *****
  • Posts: 4420
    • View Profile
Re: Correct 68 RS lower belt trim hole placement
« Reply #1 on: September 03, 2018, 01:10:32 AM »
Tony, are the original quarters and fenders no longer there?  If they're still there, I would use them as your guide for where to drill.
Jon Mello
CRG

70L34

  • Member
  • ***
  • Posts: 172
    • View Profile
Re: Correct 68 RS lower belt trim hole placement
« Reply #2 on: September 03, 2018, 04:18:10 AM »
Jon, I wish they were but they are not.

68 Ragtop

  • Member
  • ***
  • Posts: 474
    • View Profile
Re: Correct 68 RS lower belt trim hole placement
« Reply #3 on: September 03, 2018, 07:22:43 PM »
Template kits are available from all the major parts retailers.

70L34

  • Member
  • ***
  • Posts: 172
    • View Profile
Re: Correct 68 RS lower belt trim hole placement
« Reply #4 on: September 21, 2018, 01:37:37 PM »
Yes, but are they correct? I guess I should have asked the question that way.

Mike S

  • Hero Member
  • *****
  • Posts: 2676
    • View Profile
Re: Correct 68 RS lower belt trim hole placement
« Reply #5 on: September 21, 2018, 02:34:40 PM »
 When I replaced the door skin on my '67 (w/RS) I used a large piece of cardboard from a box to make a template for the wide trim.
Working in reverse by making the holes first, place the trim in the holes then trace the moldings edges and cut. Now you have a workable template.

Mike
67 04B LOS SS/RS L35 Hardtop - Original w/UOIT
67 05B NOR SS/RS L35 Convertible - Restored

SMS

  • Member
  • ***
  • Posts: 122
    • View Profile
Re: Correct 68 RS lower belt trim hole placement
« Reply #6 on: June 04, 2019, 09:02:49 PM »
Dimensions for Tony.

These are from my Norwood 68 RS Z with original never replace quarter panels.  Tony has this via email but I thought it might be helpful for others down the road to have it archived here.

Bill


SMS

  • Member
  • ***
  • Posts: 122
    • View Profile
Re: Correct 68 RS lower belt trim hole placement
« Reply #7 on: June 04, 2019, 09:05:23 PM »
.

SMS

  • Member
  • ***
  • Posts: 122
    • View Profile
Re: Correct 68 RS lower belt trim hole placement
« Reply #8 on: June 04, 2019, 09:06:05 PM »
..

SMS

  • Member
  • ***
  • Posts: 122
    • View Profile
Re: Correct 68 RS lower belt trim hole placement
« Reply #9 on: June 04, 2019, 09:06:42 PM »
...

 

anything