Author Topic: Bellhousing alignment procedure  (Read 2152 times)

camaroman1969

  • Member
  • ***
  • Posts: 141
    • View Profile
Bellhousing alignment procedure
« on: June 19, 2018, 01:44:51 AM »
Hello everyone....Question:  Does anyone here know the proper procedure on aligning a bellhousing???  We used a dial indicator, but everytime we would recheck the reading, they would "differ" from previous reading.  Used new dowel pins also.  Still no good.  Going to purchase some stock dowel pins and see if that helps.  Any assistance would be appreciated guys.  Thanks!

william

  • CRG Member
  • *****
  • Posts: 3155
    • View Profile
Learning more and more about less and less...

HustleRussell

  • Member
  • ***
  • Posts: 233
    • View Profile
Re: Bellhousing alignment procedure
« Reply #2 on: June 19, 2018, 08:00:38 PM »
Make sure your indicator is not running out of travel.
And is in contact with bore the whole 360 degrees.
Also make sure any parts of the magnetic base are
not rubbing on the bell housing.
Russ 
68 RS
69 SS