Camaro Research Group Discussion > Originality
68 Camaro TH400 with console shifter cable
SS396:
Looking at buying a GM NOS cable 3956765 which is apparently correct for my application. The issue I have is that the grommet has 3 holes around the perimeter which I guess is for screwing it to the floor. Is this right as the assembly manual doesn't mention it being screwed to the floor?
z28z11:
I don't believe the original seal was screwed into the floor - my cable on my Z11 small block looks just like this, apparently replaced at some point, and there are no holes in the tunnel around the seal where an original would have been mounted. I would like to see someone's original cable in place to see what I need to replace it with myself -
Regards,
Steve
Camarocards:
Here are a couple of pictures of my '68 BB TH400 "born with" shifter cable. Note that the grommet seals against the floor with three tabs.
Bob
KurtS:
Same as 69, btw.
z28z11:
Thought so - thanks Bob and Kurt !
Steve
Navigation
[0] Message Index
[#] Next page