Camaro Research Group Discussion > Originality
Aluminum intake BB bolts?
hgger69:
Hi,
I bought a master screw kit for my ZL-1 project but I don't really understand where all the stud bolts should go when mounting the aluminum intake?
They look like this: https://www.camarocentral.com/1969_1970_Intake_Stud_Big_Block_p/enc-338.htm
As I t says there one should be for the alternator bracket and one maybe for the fuel block, but the rest? It's four of them in the kit.
william:
Right here.
Probably intended to mount an idle solenoid bracket that was not used. 'Location C' is defined as the 3rd, 4th & 5th intake mounting points.
hgger69:
Great William, but why do they don't have extra bolts in the kit for all of us that don't need the studs?
There only three washers and not four either, strange?
Where did you get that pic?
william:
Near as I can tell all ZL1 engines were assembled with the studs, used or not. They are visible in original engine photos of ZL1 #3, a 4-speed.
The drawing is a page from the ZL1 engine assembly manual.
The
hgger69:
--- Quote from: william on July 13, 2017, 08:20:14 PM ---Near as I can tell all ZL1 engines were assembled with the studs, used or not. They are visible in original engine photos of ZL1 #3, a 4-speed.
The drawing is a page from the ZL1 engine assembly manual.
The
--- End quote ---
What? :)
Is there a ZL-1 engine assambly manual? Never heard of and is possible to download it?
I would really appreciate that kind of document in my ZL-1 build right now.....
Navigation
[0] Message Index
[#] Next page