Author Topic: Small block oil splash shield  (Read 3588 times)

Tx-Z 302

  • Member
  • ***
  • Posts: 219
    • View Profile
Small block oil splash shield
« on: June 20, 2017, 09:43:29 PM »
Anyone have a ssource on oils splash shield and the rivets ? For small block intake. Thx
Chris W

bertfam

  • Hero Member
  • *****
  • Posts: 4492
    • View Profile
Re: Small block oil splash shield
« Reply #1 on: June 20, 2017, 09:49:11 PM »
Which casting number? There are a lot of differences between them.

Ed

jack92584

  • Member
  • ***
  • Posts: 90
    • View Profile
69 Z28 / Hugger Orange /  Deluxe Houndstooth  / M21 / 4:10 Posi / GM of Canada documented


Tx-Z 302

  • Member
  • ***
  • Posts: 219
    • View Profile
Re: Small block oil splash shield
« Reply #4 on: June 22, 2017, 08:12:14 PM »
Tha is for the info.  Ed it's the 610 z intake?  I thought they (small blocks) were all the same. I learn everyday on here :)
Chris W

bertfam

  • Hero Member
  • *****
  • Posts: 4492
    • View Profile
Re: Small block oil splash shield
« Reply #5 on: June 22, 2017, 08:44:47 PM »
No, there are several. Mostly for cast iron, but even the aluminum have a few different ones.

Anyway, the 1967 & 1968 302 3917610 guard isn't listed in the P&A, but the 3932472 is (1969 302), and that one uses the 3758369 GUARD. I would assume the 3917610 uses the same guard, but again, it's not listed so I can't say for sure. Maybe Jerry can verify this since he probably has a million of these manifolds stashed in his office!

Ed

1968RSZ28

  • Hero Member
  • *****
  • Posts: 6188
    • View Profile
Re: Small block oil splash shield
« Reply #6 on: June 22, 2017, 11:05:20 PM »
In the eBay link Ed provided above, the seller (ggordog) states in the listing description...

"This will fit all small block Winters casted Chevy aluminum manifolds from 1962 on."

Paul

 

anything