Author Topic: 67 BB frame mounts - question  (Read 8083 times)

68Zproject

  • Hero Member
  • *****
  • Posts: 1868
    • View Profile
Re: 67 BB frame mounts - question
« Reply #15 on: May 26, 2017, 02:40:47 PM »
Bottom pic is drivers side.

Well, at least it's on the correct side then so not swapped side to side.
68Z28

bergy

  • Member
  • ***
  • Posts: 182
    • View Profile
Re: 67 BB frame mounts - question
« Reply #16 on: May 26, 2017, 03:36:33 PM »
there were 2 different bolts in securing my frame mounts

bcmiller

  • CRG Member
  • *****
  • Posts: 4012
    • View Profile
Re: 67 BB frame mounts - question
« Reply #17 on: May 26, 2017, 04:22:43 PM »
I would say both original. One has same markings as what I posted.

I have not seen this before and so far can't find anyone else that has. But this had to have happened more than twice.
Bryon / 1968 Camaro SS 396 coupe - now old school 468 big block
1967 Camaro RS/SS 396 coupe L35/M40 - 4 generation family project
Looking for 68 Camaro with body # NOR 181016

arocars

  • Member
  • ***
  • Posts: 28
    • View Profile
Re: 67 BB frame mounts - question
« Reply #18 on: May 28, 2017, 02:29:30 PM »
It doesn't look like your motor mounts would have moved the engine forward for additional firewall clearance, like the link posted above mentions. My first thought was to swap sides, but you mentioned that they wont swap due to a flange on the trailing edge. So, I would conclude that they are wrong for your car and replace them. Figure out what they are later on.

 

anything