Author Topic: De-rusting my drive shaft... What to preserve it with??  (Read 19344 times)

ko-lek-tor

  • Hero Member
  • *****
  • Posts: 1858
  • someday I'll get one finished
    • View Profile
Re: De-rusting my drive shaft... What to preserve it with??
« Reply #30 on: December 17, 2015, 05:28:43 PM »
I measured from the lip of top edge as seen here.
Bentley to friends :1969 SS/RS 396 owned 79
1969 SS 350 (sold)
1969 D.H.COPO replica 4spd. owned since 85
1967 302 4 spd 5.13

BillOhio

  • Hero Member
  • *****
  • Posts: 1179
    • View Profile
    • photobucket
Re: De-rusting my drive shaft... What to preserve it with??
« Reply #31 on: December 17, 2015, 06:48:50 PM »
I checked into restoguard and shipping from maryland to ohio was $20!!!
1969 Z28, Burgandy, numbers matching, 12,900 miles
1968 RS 327 4 speed
1970 Z28 M22 4:10 bought from original owner
1961 Chrysler 300G convertible

bcmiller

  • CRG Member
  • *****
  • Posts: 4010
    • View Profile
Re: De-rusting my drive shaft... What to preserve it with??
« Reply #32 on: December 18, 2015, 02:45:52 AM »

Not to change the course of the thread, but only to add to the striping color/location. I could clearly see the distinct lines on this D.S. out of a 69 P.G. 6 cyl. I carefully cleaned the area and what do you know?, it is orange & white, like Gary's. This D.S. along with my 2 big block 4spd and 1 turbo 350 and 307 appear the same in length, offset & yoke.

Could you also please post that first picture of the stripes over in the driveshaft thread which is in the Research Topics & Reports section?  Just need the first pic and the car it is from with engine and transmission combo also listed.  Thanks!

Bryon / 1968 Camaro SS 396 coupe - now old school 468 big block
1967 Camaro RS/SS 396 coupe L35/M40 - 4 generation family project
Looking for 68 Camaro with body # NOR 181016