I've been attempting to assembly the Clutch Bell Crank and Lower Clutch Push Rod. If I follow the AIM, it appears there is a major mis-alignment with the lower push rod and the clutch fork. If I flip the push rod to the other side of the bell crank arm, it appears to align well.
What is correct? Do I have some underlying alignment issue with the Bell Crank & Clutch Fork?
Here's the situation:
AIM Diagram for reference:
Lower Clutch Rod, installed per the AIM: Note big alignment gap:
If I install the push rod on the other side of the arm, (opposite side of what the AIM suggests), it appears to align just fine. What is correct??