Camaro Research Group Discussion > Originality
trim ring fit to rim
sbmiano:
I have original rims and trim rings and having trouble with 1 of the rings fitting the rim. Anyone have this issue and what did you do to get it to fit. Tried to pinch the clips but still a gap. There is a little nipple on each of the rims around the edge of each rim what is that?
Thanks
BULLITT65:
I assume this is the rally wheel with the 4 clip design trim rings? can you take a pic and show the gap?
sbmiano:
This is the trim ring with fingers all the way around. 04D 69 z
cam69aro:
sbmiano, would an 03E cars have the 4 clips or fingers all the way around ? would you be able to post a pic of the front side of the trim ring so i could see the detail of where the inside edge of the ring meets the wheel ? thanks
BULLITT65:
I have a 08C Z/28 (late 69) car, and mine came with both the 4 clip and the finger design. My 4 clip design sits snug on the wheel, but there is a small gap between the rim and the trim ring.
Navigation
[0] Message Index
[#] Next page