Author Topic: Door guards  (Read 1636 times)

Mphosix

  • Newbie
  • *
  • Posts: 4
    • View Profile
Door guards
« on: January 26, 2010, 01:10:26 AM »
Another question about the door guards that run horizonatally along the mid line of the front quarter panel, door and rear quarter panel....does anyone know if they were a factory option?  They appear to be factory guards and I have seen one other '68 with them.  The car is red with red guards.  
« Last Edit: January 26, 2010, 01:47:06 AM by Mphosix »

tmodel66

  • Hero Member
  • *****
  • Posts: 1212
    • View Profile
Re: Door guards
« Reply #1 on: January 26, 2010, 02:27:30 AM »
I am not sure but I think you are talking about body side molding in the middle of the door and  has two small pieces on each end with one on the fender and one on the quarter. If this is it they are add on after market with rivets in the center to hold it on the car and the insert pushes into the guides.
Daniel  
'69 SS 350/4 speed  Fathom Green--POP

lakeholme

  • Hero Member
  • *****
  • Posts: 2249
  • *68-12D L30/M35*
    • View Profile
Re: Door guards
« Reply #2 on: January 26, 2010, 04:00:47 AM »
Nope... edge guards yes, door guards no....
The options section here in CRG lists them all: click the CRG (red) button above and look under options.
I've seen them, too.  But that's a later aftermarket item.  Good idea though on a driver....
Phillip
HNR-AACA, Senior Master
Charlotte Autofair, Sept 24-27, 2015
Southeastern Division Spring Meet Chair, April 9, 2016
Planning Sentimental Tour, June 12-17, 2016

JohnZ

  • CRG Member
  • *****
  • Posts: 4267
    • View Profile
Re: Door guards
« Reply #3 on: January 26, 2010, 04:32:44 PM »
Those are RPO B84 Body Side Moldings, which were available on just about every Chevrolet model EXCEPT the Camaro; if you see them on a Camaro, they're aftermarket or dealer-applied.
'69 Z/28
Fathom Green
CRG

68ashgoldRS/SS

  • Member
  • ***
  • Posts: 79
    • View Profile
Re: Door guards
« Reply #4 on: January 15, 2014, 06:41:05 PM »
Late response, but my ash gold 68 had them as well (black moldings).... From what I'm hearing, they were most likely a dealer add....   ripped em off, and soldered in the holes...   ;D
Ed Denney from South Jordan Utah

1968 Camaro RS/SS -Restored
1959 Chevrolet Corvette Restomod-Project in progress
1956 Dodge D100 Pickup -Project
1936 US Soldier, Dad -Best Friend

Petes L48

  • Member
  • ***
  • Posts: 336
    • View Profile
Re: Door guards
« Reply #5 on: January 15, 2014, 06:59:24 PM »
Dealers, body shops, over the counter.  Many were adding these to cars back in the day.  I think 3M was a big supplier, various widths, colors, etc.