CRG Discussion Forum
Welcome, Guest. Please login or register.
Did you miss your activation email?
April 24, 2015, 11:21:18 PM

Login with username, password and session length
Search:     Advanced search
Welcome to the CRG Discussion Forum!
Forum registration problems: Make sure you enter your email correctly and you check your spam box first. *Then* email KurtS2@gmail for help.
112258 Posts in 12899 Topics by 4935 Members
Latest Member: rspallina
* Home Help Search Login Register
+  CRG Discussion Forum
|-+  Camaro Research Group Discussion
| |-+  General Discussion
| | |-+  69 Camaro Suspension Question
« previous next »
Pages: [1] Print
Author Topic: 69 Camaro Suspension Question  (Read 330 times)
Posts: 58

View Profile
« on: December 20, 2013, 04:54:16 PM »

My Z has the original springs  which are beginning to sag just a bit on the rear drivers side.  Can someone recommend a vendor where I can get the  front coil and rear leaf springs  that will produce the proper ride height. Thanks

69 Z
Posts: 457

View Profile WWW Email
« Reply #1 on: December 20, 2013, 07:00:04 PM »

On rear it depends if you want exact look or not. I used a set of correct looking ones from Camaro specialties. For the front look up pozzi racings site or there should be discussion on here about them. I used the Moog 6308. There is one slightly stiffer for a z that might be better on an rs car. Z sits a little lower than a small block car so make sure you get the right ones. I learned after ordering the small block springs from hbc after they said that's what everyone uses. Car looked like motor was out

1969 Z28, Burgandy, numbers matching, 12,900 miles
1967 Plymouth GTX Hemi, 4 speed, dana
1961 Chrysler 300G convertible
Pages: [1] Print 
« previous next »
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.20 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!
Page created in 0.153 seconds with 18 queries.