Author Topic: 69 Camaro Suspension Question  (Read 2061 times)


  • Member
  • ***
  • Posts: 64
    • View Profile
69 Camaro Suspension Question
« on: December 20, 2013, 09:54:16 PM »
My Z has the original springs  which are beginning to sag just a bit on the rear drivers side.  Can someone recommend a vendor where I can get the  front coil and rear leaf springs  that will produce the proper ride height. Thanks
69 Z


  • Hero Member
  • *****
  • Posts: 1179
    • View Profile
    • photobucket
Re: 69 Camaro Suspension Question
« Reply #1 on: December 21, 2013, 12:00:04 AM »
On rear it depends if you want exact look or not. I used a set of correct looking ones from Camaro specialties. For the front look up pozzi racings site or there should be discussion on here about them. I used the Moog 6308. There is one slightly stiffer for a z that might be better on an rs car. Z sits a little lower than a small block car so make sure you get the right ones. I learned after ordering the small block springs from hbc after they said that's what everyone uses. Car looked like motor was out
1969 Z28, Burgandy, numbers matching, 12,900 miles
1968 RS 327 4 speed
1970 Z28 M22 4:10 bought from original owner
1961 Chrysler 300G convertible