Author Topic: 1969 Camaro SSRS Wire Harness Restoration DIYS  (Read 4843 times)

french69ssrs

  • Newbie
  • *
  • Posts: 8
    • View Profile
1969 Camaro SSRS Wire Harness Restoration DIYS
« on: October 18, 2013, 03:01:04 PM »
Hi All
I am Restoring my 1969 SSRS Camaro and it has been Modified/ Hacked in Various areas, Dash Harness and Engine Bay.
I have some wires broken off at the Terminals where the Turn Signal Wiring goes into the "Hamonica Connector" and was looking for these type of Male Terminal Spades.

I found them -     
http://www.repairconnector.com/search.php?search_query=GM+Pak+Con+OEM&x=9&y=11

     And my Wire is a 14 gage so it will be

     GM Pak Con OEM Repair Terminal Male 16 14 AWG

http://www.repairconnector.com/products/GM-Pak%252dCon-OEM-Repair-Terminal-Male-16%252d14-AWG.html

They have a Repair Kit, I ordered it with a few Extras. I'm sure these were used for many years and across All the GM lines.

Again, Thanks

Timmy

sixt9x33rs

  • Hero Member
  • *****
  • Posts: 980
    • View Profile
Re: 1969 Camaro SSRS Wire Harness Restoration DIYS
« Reply #1 on: October 25, 2013, 03:44:46 AM »
If your wiring harness is hacked into, I would consider a new quality harness. There are a few vendors that recreate a very nice harness. That last thing you want is a fire. I have put two on Corvettes...lectric limited was one supplier and the other from a group out West. Don't recall the name.
'69 RS Z/28 65B, 711 Flat hood no spoiler, endura, 4:10 43K miles
69 X77 Z/28 69 69 711 Original Paint Unrestored (Sold)
'69 X66 Convertible 69B 712 auto, (Sold) 44K miles