I've tried to post this subject twice, but it didn't appear to show up on the discussion board. I apologize if it's redundant or if it has been discussed before. I was looking through some of my old parts stash over the weekend & noticed that the original grilles all had round ejector pin scars behind the rectangular cut outs in the grille. In fact, a couple of the ejector pins must have been removed from the mold in one of the grilles, because a long plastic projection was left on the part where the ejector pin should have been. I've always looked for the "bone" colored plastic to ID original grilles - is this another way of IDing them? ( i.e - looking for the round ejector pins?). I don't believe that I have seen the round pins in that location on repro grilles.