CRG Discussion Forum
Welcome, Guest. Please login or register.
Did you miss your activation email?
August 29, 2014, 03:11:41 PM

Login with username, password and session length
Search:     Advanced search
Welcome to the CRG Discussion Forum!
Forum registration problems: Make sure you enter your email correctly and you check your spam box first. *Then* email KurtS2@gmail for help.
103645 Posts in 12180 Topics by 4697 Members
Latest Member: greygoose01
* Home Help Search Login Register
+  CRG Discussion Forum
|-+  Camaro Research Group Discussion
| |-+  General Discussion
| | |-+  1969 RS and Cowl induction hole
« previous next »
Pages: [1] Print
Author Topic: 1969 RS and Cowl induction hole  (Read 637 times)
DyRally-Z1986
Member
***
Posts: 61


View Profile Email
« on: September 17, 2013, 06:26:27 AM »

Does someone know the size of the RS vacuum hole and the size of the cowl induction hole that are located in the fire wall? I was comparing pictures last night of two of my Dad's cars and it doesn't appear that the holes are consistent in their location (close, but not precise).
Logged
JohnZ
CRG Member
*****
Posts: 4076


View Profile Email
« Reply #1 on: September 17, 2013, 10:43:13 AM »

Does someone know the size of the RS vacuum hole and the size of the cowl induction hole that are located in the fire wall? I was comparing pictures last night of two of my Dad's cars and it doesn't appear that the holes are consistent in their location (close, but not precise).

Those holes (location and size) are shown in the Assembly Manual in section Z22 (RS vacuum hole) and in section ZL2 (cowl induction harness hole).
Logged

'69 Z/28
Fathom Green
CRG
dannystarr
Hero Member
*****
Posts: 584


View Profile
« Reply #2 on: September 17, 2013, 11:49:44 AM »

Here is a location hole. I think I got this off this site from JohnZ. Do a search and you should find more pictures showing bare firewalls.... Danny
Logged
1968RSZ28
Hero Member
*****
Posts: 4685



View Profile
« Reply #3 on: September 17, 2013, 12:06:26 PM »

Attached is a photo showing both holes and there location.

Paul
Logged
DyRally-Z1986
Member
***
Posts: 61


View Profile Email
« Reply #4 on: September 17, 2013, 12:26:00 PM »

Okay, I ordered the assesmbly manual today. I'm pretty good on the location, I was trying to figure out the diameter of each hole.
Logged
ZLP955
Member
***
Posts: 437



View Profile
« Reply #5 on: September 17, 2013, 04:02:18 PM »

The '69 AIM calls up hole for Z22 Rally Sport as 1.00" diameter (UPC 0, sheet A9), and cowl induction wiring hole as 0.75" diameter (UPC ZL2, sheet A5).
Logged

Tim - New South Wales, Australia
04A VN '69 z/28 69-69 715 ex-E/MP
Pages: [1] Print 
« previous next »
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.19 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!
Page created in 0.274 seconds with 18 queries.