Author Topic: 1969 RS and Cowl induction hole  (Read 953 times)

DyRally-Z1986

  • Member
  • ***
  • Posts: 67
    • View Profile
1969 RS and Cowl induction hole
« on: September 17, 2013, 11:26:27 AM »
Does someone know the size of the RS vacuum hole and the size of the cowl induction hole that are located in the fire wall? I was comparing pictures last night of two of my Dad's cars and it doesn't appear that the holes are consistent in their location (close, but not precise).

JohnZ

  • CRG Member
  • *****
  • Posts: 4277
    • View Profile
Re: 1969 RS and Cowl induction hole
« Reply #1 on: September 17, 2013, 03:43:13 PM »
Does someone know the size of the RS vacuum hole and the size of the cowl induction hole that are located in the fire wall? I was comparing pictures last night of two of my Dad's cars and it doesn't appear that the holes are consistent in their location (close, but not precise).

Those holes (location and size) are shown in the Assembly Manual in section Z22 (RS vacuum hole) and in section ZL2 (cowl induction harness hole).
'69 Z/28
Fathom Green
CRG

dannystarr

  • Hero Member
  • *****
  • Posts: 1116
    • View Profile
Re: 1969 RS and Cowl induction hole
« Reply #2 on: September 17, 2013, 04:49:44 PM »
Here is a location hole. I think I got this off this site from JohnZ. Do a search and you should find more pictures showing bare firewalls.... Danny

1968RSZ28

  • Hero Member
  • *****
  • Posts: 5245
    • View Profile
Re: 1969 RS and Cowl induction hole
« Reply #3 on: September 17, 2013, 05:06:26 PM »
Attached is a photo showing both holes and there location.

Paul

DyRally-Z1986

  • Member
  • ***
  • Posts: 67
    • View Profile
Re: 1969 RS and Cowl induction hole
« Reply #4 on: September 17, 2013, 05:26:00 PM »
Okay, I ordered the assesmbly manual today. I'm pretty good on the location, I was trying to figure out the diameter of each hole.

ZLP955

  • Hero Member
  • *****
  • Posts: 778
    • View Profile
Re: 1969 RS and Cowl induction hole
« Reply #5 on: September 17, 2013, 09:02:18 PM »
The '69 AIM calls up hole for Z22 Rally Sport as 1.00" diameter (UPC 0, sheet A9), and cowl induction wiring hole as 0.75" diameter (UPC ZL2, sheet A5).
Tim - 04A VN '69 z/28 69-69 715 ex-E/MP