Camaro Research Group Discussion > Originality
68 SS RS Wheel well moldings
Ue:
Is there a difference between 1968.... / Standard / RS / SS / wheel well moldings?
Classic industries has a set that states RS only.
1-What are the differences?
2-Which type would a SS/RS have? Am I right to assume RS?
Link to Classic Industries RS set - http://www.classicindustries.com/camaro/parts/*R5121.html (looks like 69 in the pic though)
Link to Classic Industries single - http://www.classicindustries.com/camaro/parts/7795064.html
Ue:
Thanks for looking but I see this has been answered before...
Please feel free to delete this thread.
Re: ralley sport wheel well molding 1968 ss/rs
« Reply #1 on: 07 February 2008, 16:16:27 »
Reply with quote
Yes, on the 68 RS the wheel opening moldings are shorter and different part #'s than the 67 RS/SS and 68 SS models. They can be cut and I know a template exists but I have never tried it myself. The 68 RS moldings come up for sale on a fairly regular basis and if you are'nt in a hurry you might wait and see if you can pick up a set and sell the others. If no one else comes through with the template I have one somewhere and will dig it out for you. I'd just hate to see you chop up an expensive set of moldings and not be happy with the results.
Report to moderator Logged
Pat Railsback
67 0-1 L35/M40
68 L78/M22
69 Z11 L34/M20
jeff68:
For 68, the front moldings differed between Z21 Style Trim Group & RS. The rear moldings were the same for both.
Here is additional info on the 68 moldings:
http://www.gmpartswiki.com/getpage?pageid=64641
http://www.gmpartswiki.com/getpage?pageid=64643
Ue:
Thanks jeff68 and everyone else at CRG.
This site is an absolute wealth of information!
Ue:
OK, going to kick this thread off again...
Would a 68 RS Camaro (build Nov 67) front wheel arch mouldings stop at the rocker molding or continue down to the bottom of the wheel arch of the rear of the front guard?
This thread states there was a "discontinued" style. - http://www.camaros.org/forum/index.php?topic=11133.0
If so, does anyone have a detailed picture or template for me to cut my classic Industrie repos?
If not, does anyone have a picture of the rocker moulding meeting up with the wheel arch mould?
A (poor) example is below.
Cheers, Ue.
Navigation
[0] Message Index
[#] Next page