« previous next »
Pages: [1]

Author Topic: what engine motor mount did you use on z28  (Read 2887 times)

BillOhio

  • Hero Member
  • *****
  • Posts: 1179
    • View Profile
    • photobucket
what engine motor mount did you use on z28
« on: April 01, 2013, 02:58:08 AM »
Getting parts ready to install engine and noticed the mounts on engine were the original non locking ones. One had a crack in rubber so I figured to get a new set. Is it a good idea to switch to the locking ones? I think the wider one was the cracked one.
Thanks
Logged
1969 Z28, Burgandy, numbers matching, 12,900 miles
1968 RS 327 4 speed
1970 Z28 M22 4:10 bought from original owner
1961 Chrysler 300G convertible

lynnbilodeau

  • Member
  • ***
  • Posts: 395
    • View Profile
Re: what engine motor mount did you use on z28
« Reply #1 on: April 09, 2013, 04:02:36 AM »
Well, GM switched to the locking ones eventually.  Unless you are planning to have the car judged in a class that will ding you, I would just use the Anchor replacment interlocking mounts.  Just put a pair on my 69 Z and they fit perfectly.
Logged

69Z28-RS

  • Hero Member
  • *****
  • Posts: 5778
  • owner since 4-Apr-1976
    • View Profile
Re: what engine motor mount did you use on z28
« Reply #2 on: April 09, 2013, 04:18:45 AM »
Optionally, use your remaining orignal good one on the RH side (passenger side of the engine) and buy an interlocking one for the LHS...  GM may have even swapped out some LHS units for interlocking ones during first year maintenance activity??
Logged
09C 69Z28-RS, 72 B 720 cowl console rosewood tint
69 Corvette, '60 Corvette, '72 Corvette
90 ZR1 red/red #246, 90 ZR1 white/gray #2466
72 El Camino, '55-'56-'57 Nomads, '55-'57 B/A Sedan
Pages: [1]
« previous next »
 

anything