« previous next »
Pages: [1]

Author Topic: 67 350 metal vacum line correct  (Read 2942 times)

pracing

  • Newbie
  • *
  • Posts: 4
    • View Profile
67 350 metal vacum line correct
« on: December 19, 2012, 07:32:07 AM »
Going back to the organal carb on my 67 RS/SS 350/295 Hp & looking for the correct vacum line routing from dist to carb. It had a holley carb & it not sure if the metal line is correct
 
Thanks
Logged

bertfam

  • Hero Member
  • *****
  • Posts: 4492
    • View Profile
Re: 67 350 metal vacum line correct
« Reply #1 on: December 19, 2012, 02:54:39 PM »
The 67 L48 engine (350/295) used a Rochester Q-Jet, so you need to get THIS ONE.

Ed
Logged

z28z11

  • Hero Member
  • *****
  • Posts: 1853
    • View Profile
Re: 67 350 metal vacum line correct
« Reply #2 on: December 21, 2012, 12:32:19 AM »
Hey pracing -

I've got one of these if you need an original - be glad to send it to you if you'll pay the freight. I'll try to dig it out of the frozen garage tonight and get a pic if you want -

Regards,
Steve
Logged
1968 Z28 M21/U17 BRG/W 1967 Chevy ll Nova SS 
1969 Z28 X77/M20/VE3 LeMans/W
1969 L78 X66/N66 Cortez/BVT
1969 Z11 L48/M35/C60/C06  1949 3100 5wd 235/6

68camaroz28

  • Hero Member
  • *****
  • Posts: 2233
    • View Profile
Re: 67 350 metal vacum line correct
« Reply #3 on: December 21, 2012, 12:54:26 AM »
Maybe its correct for the q-jet but for our Holley set up the kits have the wrong small piece to the carb. Our orig. vs. a piece of the stripped vac. hose.
Our original

Original to left vs. kits piece.

Logged
Chick
68 Z/28 NOR 01B Orig motor/trans/rear
69 Z/28 NOR 07A Orig Block & GM Cross-ram/carbs
69 L34 Rest. Nova Father/Son Car
69 L78 Surv Nova Purch 4/69 31K miles
67 L89 Corv Tribute
68 Corv 427/400 Orig motor
07 Corv Z06
R 68Z build- http://www.camaros.net/forums/showthread.php?t=182584

bertfam

  • Hero Member
  • *****
  • Posts: 4492
    • View Profile
Re: 67 350 metal vacum line correct
« Reply #4 on: December 21, 2012, 04:09:14 PM »
I've been told that the DOC REBUILD vacuum hoses are "correct". I haven't checked it out myself, but the same hose was used throughout GM for a number of years, not just Corvette and Camaro.

By the way, there are a couple of good pictures of the Q-Jet tube and hoses in THIS thread. This engine is a 68 L30 (327/275) but the setup is the same as the 67 L48 engine (350/295).

Ed
Logged
Pages: [1]
« previous next »