1
Decoding/Numbers / Re: Hurst shifter identification help
« on: November 12, 2016, 10:48:04 PM »
It looks like 2 levers
News:
Welcome to the CRG Discussion Forum!
Classified ads are not allowed on the forum.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Decoding/Numbers / Re: Hurst shifter identification help
« on: November 12, 2016, 06:13:55 PM »
i don't know if the picture is clear enough
3
Decoding/Numbers / Hurst shifter identification help
« on: November 11, 2016, 11:38:33 PM »
Hi, I am trying to figure out what this Hurst shifter came out of.
I found it in a box of auto parts after my grandfather died, so any info would help greatly.
It is labeled - Hurst Dual Pattern With Syncro/Loc
Also there is a number above that - 288671
The large mounting bracket also has a number - 1581D
It is a long chrome squared handle with a black ball.
It has about a 60deg bend in the lever.
And it has HURST stamped into the middle of the handle.
Any info would be amazing, sorry if this is a bad post.
I found it in a box of auto parts after my grandfather died, so any info would help greatly.
It is labeled - Hurst Dual Pattern With Syncro/Loc
Also there is a number above that - 288671
The large mounting bracket also has a number - 1581D
It is a long chrome squared handle with a black ball.
It has about a 60deg bend in the lever.
And it has HURST stamped into the middle of the handle.
Any info would be amazing, sorry if this is a bad post.
Pages: [1]