76
General Discussion / Re: Shifter adjustment Help
« on: April 20, 2017, 09:26:03 AM »do you have the rod in the correct hole on the trans reverse lever ?
there are two holes and the lower hole is for the trans lockout rod
Hello,You should be able to screw the rod into the shifter adjustment nub further to shorten the travel. That's part of the basic set up procedure.
I need your advice ,
When I got my car a BB 69 RS/SS non numbers
Car, it had a Blatantly wrong shifter ....
So I decided to buy a correct rebuilt
3138 shifter assembly, then I got a
supposedly correct aftermarket BB Linkage with
Mounting plate set up.
Everything installed and shifts great ,
except when I go into reverse , it seems that
The shifter travel is to long , pulling the reverse
Lever to a full 90 degrees from the neutral"down" position
Then that angle is such that I can't shift out of reverse.
Thanks for any help you can offer.
Jim
Thanks , I am certainly no expert on this ,
but with the shifter in the neutral position,
And all three transmission shift levers in the down,
Neutral position , there is no guess work as
To rod adjustment length?