Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - HustleRussell

Pages: 1 [2] 3 4 5
16
Mild Modifications / Small block with th400
« on: December 10, 2017, 01:50:51 AM »
I’m thinking about installing a 350 smallblock, th400 and 12 bolt rear end in my 68 rs for drag strip duty. Later on the smallblock probably will get changed over to a bigblock. My question is should I use bigblock motor mounts on a smallblock with a th400 crossmember and th400 driveshaft? So when I change over to bigblock nothing has to change, except engine?

17
Decoding/Numbers / MC1 Maincase Casting Number
« on: November 22, 2016, 02:04:01 AM »
CRG lists the MC1 main case casting # 3911940 in the transmission section. My # is 3911982.

http://www.camaros.org/trans.shtml


18
Site Comments/Discussion / Pictures
« on: November 20, 2016, 06:15:04 AM »
I've noticed that some posted pictures can be seen without logging in and other pictures can only be seen by logging in. Just wondering how does this happen?

19
6-cylinder Camaros / L22 air cleaner
« on: November 09, 2016, 12:54:39 AM »
I've Installed an L22 from a 1972 Pontiac Ventura into a 1968 RS V-8 Camaro. I have a clearance issue with the air cleaner and windshield washer reservoir.

20
Decoding/Numbers / Is this my born with transmission?
« on: November 05, 2016, 09:30:54 PM »
VIN 124379N610048

21
General Discussion / Michael Myers steals 67 camaro
« on: October 30, 2016, 01:23:24 AM »

23
6-cylinder Camaros / 68 L22 Clone
« on: October 11, 2016, 11:29:05 PM »
Got the engine (born in 72 ventura) and transmission (tko 5 speed) bolted together. 96 s10 4 cylinder clutch worked like a charm.

25
6-cylinder Camaros / 67 L22 on CL
« on: September 13, 2016, 12:13:44 AM »

26
Mild Modifications / 250 6 & tremec 5 speed.What clutch?
« on: July 08, 2016, 12:43:21 AM »
Just pulled a 250 from 72 Ventura. Would like to give it a test run in 68 rs. I've got a tremec 5 speed with 26 spline input shaft. The clutch from the 250 is 9.0" and 10 spline & the pressure plate measures 10.2". Does anyone make a clutch for this application? thanks.

Pages: 1 [2] 3 4 5