Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - 1969Z27

Pages: [1] 2 3 ... 14
Great car.

I have the same issue with my rear brakes - the drum punchouts have not been removed. Can you get your rear drums off? I think I'm going to have to knock mine out to get them off (unless someone knows a trick).

Note the C removed from the axle code. That's not chance....

I have used two flathead screwdrivers inserted thru slot in back plate. One to push the adjusting lever away from adjusting screw, and the other screwdriver to turn the adjusting
 screw until the drum will slip off. 

6-cylinder Camaros / Re: 1969 L22 with ac
« on: November 04, 2019, 02:31:15 AM »

General Discussion / Re: VIN #
« on: September 04, 2019, 08:22:06 PM »
Did the factory make any Camaros with N66 wheels and ZL2 hood on same car?

Garage Talk / Re: 81 camaro I saw
« on: December 06, 2018, 02:53:15 PM »
One way to tell itís an Ď81 is lack of a covey hole in console below the radio. Starting in Ď81 the computer was installed in this space.

Since the factory transmission is long gone I would think a mc1 Muncie 3 speed would be a better replacement. It is much more rare than the m20. Not more desirable though.

General Discussion / Re: 12 Bolt Axle Asm Weight
« on: August 23, 2018, 01:21:56 AM »
Mike, I've got a 1970 Monte Carlo 12 bolt fully assembled drum to drum with cables.

210 lb's.

The original question was answered in first reply.

Decoding/Numbers / DZ block on craigslist
« on: August 03, 2018, 12:14:46 AM »
Move to orphans? I can't make out all of partial vin.

General Discussion / Re: 1969 Camaro Z/28
« on: July 24, 2018, 01:57:11 AM »
A first generation Z/28 with ac 🧐

General Discussion / Re: Bellhousing alignment procedure
« on: June 19, 2018, 08:00:38 PM »
Make sure your indicator is not running out of travel.
And is in contact with bore the whole 360 degrees.
Also make sure any parts of the magnetic base are
not rubbing on the bell housing.

General Discussion / Re: "muscle car" without posi
« on: June 19, 2018, 12:30:56 AM »
I have a 67 6 banger with a born with 3:55 Posi..... Sweet!

Welcome to CRG Pat.
I'm a big fan of the inline six. Would love to see
some pics and some history of your 67 6 banger.

Pages: [1] 2 3 ... 14