Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ban617

Pages: 1 2 [3] 4 5 ... 14
31
Garage Talk / Re: Z28 Emblems.... HOW MANY have been made??
« on: April 05, 2016, 06:29:28 PM »
Well from the 10,027 number we need to subtract the Copo's & Pace cars then take that number divided into 20,302 and then would have an idea of the total Z/28's with the Zl2 .

32
Garage Talk / Re: Z28 Emblems.... HOW MANY have been made??
« on: April 05, 2016, 05:09:52 PM »
From Sept - Dec 68 ,I came up with 83,803 cars built .. 10,026 cars had the ZL2 option total ..I wonder why
you couldn't get the 9737 option with the bigger sway bar & 140 speedo on a Z/28 ?

33
Garage Talk / Re: Z28 Emblems.... HOW MANY have been made??
« on: April 05, 2016, 01:12:25 PM »
You could get a rough idea on the total built from the Vin breaks in Jerry's book ... I was thinking about 1 in 10 had the ZL2 .

34
Garage Talk / Re: Z28 Emblems.... HOW MANY have been made??
« on: April 05, 2016, 09:47:44 AM »
All Z/28's had Zl2 hoods & spoilers ...& 69 Z/28's had headers & Crossram's in the trunk from the factory...
   Just a few things that some people believe ..,

35
Decoding/Numbers / Re: BE axle?
« on: April 04, 2016, 10:33:35 PM »
04 23 would that be the date ? According to the trim tag 09D ...

36
General Discussion / Re: Documentation
« on: April 04, 2016, 10:17:03 PM »
Looks like an almost twin to mine except for the black hat , good looking car

37
Restoration / Re: Pistons for a 1967 327/275
« on: April 04, 2016, 12:22:12 AM »
Personally I would go with the forged Pistons over the cast / hyperuetectic pistons ..

38
General Discussion / Re: CRG Shifter Report
« on: April 02, 2016, 11:53:25 AM »
Kurt , Martin nice job just read through the report ...

39
Restoration / Re: door sills travesty
« on: March 31, 2016, 03:18:22 PM »
Trim Parts $68.95 with riveted tag & screws .

40
General Discussion / Re: HBC warning. Not Made in the USA
« on: March 31, 2016, 02:24:55 AM »
Ok , what is everyone putting on the tanks to preserve the finish ? Satin clear or ?

41
General Discussion / Re: HBC warning. Not Made in the USA
« on: March 30, 2016, 06:42:54 PM »
The japanese did the made in usa years ago and fooled people to buy their products they were made in usa japan and not U.S.A.

42
Restoration / Re: door sills travesty
« on: March 29, 2016, 10:51:31 PM »
Trim parts has them with the rivets I believe ...

43
Dale Z/28 , on the hot start / heat soaked issue with the starter the ford style solenoid does a great job to prevent this from happening...

44
Decoding/Numbers / Re: Caveat Emptor...body tag sure looks new
« on: March 28, 2016, 10:39:58 PM »
I messaged him about the tag & he replied "it was damaged while cleaning with a wire wheel the metal is very thin " ...,

45
Garage Talk / Re: Gross horsepower vs. Net horsepower
« on: March 27, 2016, 04:37:20 AM »
Would it be fair to say you lose 20% hp on average going from an engine dyno to a rear wheel dyno ?

Pages: 1 2 [3] 4 5 ... 14