Messages

31

General Discussion / Re: Another 69Z project for sale (orange this time)

« on: December 11, 2018, 12:37:29 AM »

Don't think so - horseshoe shifter - and should have left it in the river it was pulled.

32

Maintenance / Re: Coolant crystals

« on: November 24, 2018, 04:37:13 PM »

As Puress suggests, run a ground wire from radiator to ground as this action put radiator on the same voltage level/ground as the rest of the system.
Change coolant also and use deionized water.

33

Decoding/Numbers / Re: Caveat Emptor...altered/swapped tag

« on: October 26, 2018, 12:44:32 AM »

Thanks, William. Mono-leaf perches on rear axle(67)? Look thin compared to multi-leaf perches.
I suggest this because I don't see pads about springs in perches.
Rear drum is not going to fit onto axle stub shown - aftermarket axles due to extra holes?
Rear white stripes too close to rear window?
Parking brake should be under pipes, not over them.
Should not spare tire match the ad and the other four tires?
Nice paint/reflection. I could be mistaken.

34

Maintenance / Re: 302 Valve adjustment

« on: October 21, 2018, 10:26:41 PM »

Best method is EOIC - Exhaust opening - adjust intake; Intake closing - adjust exhaust.
This method has the lifter on base corcle of lobe. Start with firing order and follow through.
You're welcome.

35

General Discussion / Re: VERY interesting Garage Find Today, NOT a Camaro

« on: September 26, 2018, 11:33:59 PM »

Nice find! at any rate.  Nice ride and I'd get it in a heartbeat.

36

Original Cars and Details / Re: Family survivor 69 Camaro

« on: August 19, 2018, 11:09:13 PM »

Awesome story/thread and Thanks for the pictures.
I am surprised the exhaust pipe studs DID NOT break and OE nuts did not hang up.

37

General Discussion / Original 1968 Camaro Owners

« on: June 12, 2018, 02:50:29 PM »

Original owners from my hometown and still married - congratulations !!!
https://www.hemmings.com/magazine/mus/2018/07/The-Practical-Camaro/3751872.html

38

General Discussion / Re: 69 Holley kickdown switch bracket installation.

« on: May 27, 2018, 11:22:07 AM »

From '69 AIM

39

General Discussion / Re: My new project....

« on: May 10, 2018, 11:50:19 PM »

Congrats, Austin, on your find.
New journey and I wish you the best of luck with her.

40

General Discussion / Re: Typical price value for a 67 convertible.

« on: May 10, 2018, 11:47:20 PM »

Yes, I see 3L is prevalent, steering wheel button and back-up lights below bumper.
Nice in seeing Montgomery Wards Body side molding.

41

General Discussion / Re: Typical price value for a 67 convertible.

« on: May 10, 2018, 06:51:00 PM »

Looks to be a 4P on Trim Tag, so SS?

42

Decoding/Numbers / Re: Decoding tag

« on: April 29, 2018, 11:27:02 AM »

And a flat hood, as well

43

General Discussion / Re: Driveshaft Research Report

« on: April 11, 2018, 11:17:30 PM »

Very nice. good work.

44

Originality / Re: Big block heater hose question!

« on: April 06, 2018, 12:02:22 AM »

Supply hose to core is 5/8 inch from intake manifold.
Return hose is 3/4 inch to water pump nipple.

45

Restoration / Re: 1967 front fender valence design

« on: March 27, 2018, 12:42:10 AM »

Holes are needed if front spoiler is attached as these holes are for the rods holding bottom of spoiler.