CRG Discussion Forum
Welcome, Guest. Please login or register.
Did you miss your activation email?
April 27, 2015, 10:36:28 AM

Login with username, password and session length
Search:     Advanced search
Welcome to the CRG Discussion Forum!
Forum registration problems: Make sure you enter your email correctly and you check your spam box first. *Then* email KurtS2@gmail for help.
112328 Posts in 12905 Topics by 4940 Members
Latest Member: navan
* Home Help Search Login Register
  Show Posts
Pages: 1 2 [3]
31  Camaro Research Group Discussion / Restoration / Re: Console bracket & U-joint on: November 10, 2012, 11:36:34 AM
Chick, my 68 was natural with a little primer overspray.
32  Camaro Research Group Discussion / Restoration / Quarter Window Well Water Drain on: November 10, 2012, 11:33:43 AM
I recently got my 68 back from having the quarters replaced. As I am installing the quarter windows, I notice that I do not see any way for water that gets in through the window to drain. Are there supposed to be drain holes in the bottom of this area? If so, does any one have a photo of what they look like?
33  Camaro Research Group Discussion / Restoration / Re: 68 RS Conv Rear Harness Routing Help on: October 24, 2012, 08:36:43 PM
Awesome Ed - I have a fold-down rear seat and power top as well - this is just what I need! Thanks!
34  Camaro Research Group Discussion / Restoration / 68 RS Conv Rear Harness Routing Help on: October 24, 2012, 07:06:28 PM
I am in the middle of my restoration and am having a brain cramp on the correct routing of the rear harness. The area I am not sure of is from the passenger compartment into the trunk. Does it go through the area for the convertible top mechanism, or does it go outside that area along the seat back frame? If anyone has any pictures, I'd be grateful!
35  Camaro Research Group Discussion / Restoration / Upper Dash Windshield Bracket - 68 RS Conv on: October 04, 2012, 01:17:18 PM
Help - I screwed-up!

I replaced the upper dash with an aftermarket unit from NPD (after a little work, it fit well). Yesterday, I went to put the windshield in and found the aftermarket piece did not have holes for the 2 windshield support brackets or the 8 support clips. No problem you say - just take the measurements off the old one? Well, this is where I find that my scrap guy was too quick - the old one is gone. Does anyone have the locations.....or any other ideas?
Pages: 1 2 [3]
Powered by MySQL Powered by PHP Powered by SMF 1.1.20 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!
Page created in 0.097 seconds with 18 queries.