CRG Discussion Forum
Welcome, Guest. Please login or register.
Did you miss your activation email?
November 23, 2014, 05:28:04 PM

Login with username, password and session length
Search:     Advanced search
Welcome to the CRG Discussion Forum!
Forum registration problems: Make sure you enter your email correctly and you check your spam box first. *Then* email KurtS2@gmail for help.
106506 Posts in 12421 Topics by 4787 Members
Latest Member: Oilron14
* Home Help Search Login Register
  Show Posts
Pages: [1]
1  Camaro Research Group Discussion / Mild Modifications / Re: 69 Camaro Auto Trans Swap on: May 18, 2011, 09:55:32 AM
Hey guys any suggestions on clutch pressure plates, I'm leaning towards Hayes 11" but I'm open to suggestions. Also it looks like I may have to cut a hole in my floor for the shifter, whats the best way to line this up correctly? Any help is greatly appreciated
2  Camaro Research Group Discussion / Mild Modifications / Re: 69 Camaro Auto Trans Swap on: May 05, 2011, 12:43:24 AM
Thank-you, I have a much better idea of what is going to be the right muncie, I appreciate the help.
3  Camaro Research Group Discussion / Mild Modifications / Re: 69 Camaro Auto Trans Swap on: May 02, 2011, 09:42:53 AM
William, thanks for the reply. In your opinion what 1st gear ratio would be best? 2.52 or Lower? I really don't drive the car on the highways and would like the torque off the line. Your thoughts?
4  Camaro Research Group Discussion / Mild Modifications / 69 Camaro Auto Trans Swap on: April 30, 2011, 11:41:30 AM
Hi, I'm new to the forum and need some advice. I have a 69 LM1 Camaro with 350 - turbo 350 auto trans that I would like to swap for a 4speed, Console car horseshoe shifter. The question is which 4 speed?  I have contacted a few people in the industry some suggest the M20 wide ratio other suggest the M22 Close ratio. I have considered the tremec tko500 for the overdrive, but would like to keep the somewhat of the originality of the muncie trans.
I will be swapping the 350 engine 255hp for a 383 stroker with 525hp. also have 3.73 gears in the 12bolt.
Would I need to change the drive shaft and trans cross member with this trans swap?
Any help would be appreciated....
Pages: [1]
Powered by MySQL Powered by PHP Powered by SMF 1.1.20 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!
Page created in 0.085 seconds with 19 queries.