421
Originality / Re: Comfort Weave Seats
« on: August 19, 2021, 05:58:33 PM »
I heard somewhere that SMS in Canby Oregon has some. Don't know for sure...Joe
News:
Welcome to the CRG Discussion Forum!
Classified ads are not allowed on the forum.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
422
Originality / Re: 69 SS hood underhood pictures
« on: August 18, 2021, 04:06:53 AM »Got the hood home,finally took out of the truck.Took the louvers out. Has the alignment hole, doesn't have the tabs or the 3 small drain holes as shown in previous pictures from Ed. Doesn't match what is shown in the 69 Camaro AIM. Had the #1 chrome ornaments L &R.H. , #3927469-70, #3 3927468 screens (2), #4 3927471-2 Plate L. & R.H., 11 of the 12 nut #9419756. Does not have the #3 3898146 Seal (2), #6 3903974 TUBE-DRAIN (2) ,that goes in the holes that are not in this hood. Still looking for a GM original hood for my 69 SS. Thanks to all. Good luck on all your projectsPost a picture...Joe
423
General Discussion / Re: What's it worth?
« on: August 13, 2021, 01:09:07 AM »
Pretty good. Thanks for the clarification....Joe
424
General Discussion / Re: What's it worth?
« on: August 12, 2021, 08:41:30 PM »Yes Pontiac engine have VINS in 69.James
The customer of mine on the L78 pace car recently bought a 69 TA which lost 7 points at the Pontiac Nationals I will see if he will chime in here.
7 points out of how many? For non "born with" engine?
Thank you, Joe
425
Mild Modifications / Re: 1969-Z wheels
« on: August 11, 2021, 06:28:20 PM »
Any modification from factory correct restoration isn't factory correct. Only you can decide what you want...Joe
426
Originality / Re: 69 SS hood underhood pictures
« on: August 10, 2021, 11:00:22 PM »
Here you go...Joe
428
Restoration / Re: 1969 deluxe door panel problems
« on: August 02, 2021, 09:05:02 PM »
Thank you...Joe
429
Restoration / Re: 1969 deluxe door panel problems
« on: August 02, 2021, 03:46:19 PM »
Not winning. Thanks for asking. They were in Tucson sun for many hours before installing them. Once they cooled down they returned to the way they were before. Joe
431
General Discussion / Re: Points vs. Electronic Ignition
« on: July 29, 2021, 02:29:29 PM »
I've always run quality points in my cars....Joe
432
Maintenance / Re: Replacement of Horn Contact - 69 Camaro part C-2819-10 NPD
« on: July 28, 2021, 05:44:44 PM »
How does the pin & spring go in? Does the pin go in 1st or the spring. Horn never worked on this car. Standard wheel 1969 w/tilt. Thank you, Joe
433
General Discussion / Re: L78 Throttle Rod Location
« on: July 28, 2021, 11:43:30 AM »
On the z/28. which is also a Holley, it shows position #3. Wonder if it's the same?....Joe
434
Restoration / Re: 1969 Camaro Temp Sending Unit - U17 Wire Terminal
« on: July 27, 2021, 07:27:38 PM »
Am I missing something here? The assm manual calls for a nut & lock washer. In 1981, that's what my car had/has. Still has the OE sender.....Joe
435
General Discussion / Re: 69 Temp Sending Unit
« on: July 26, 2021, 05:10:30 PM »
My 69 396 car with gauges has threaded connection. I would think yours is the same. It's the gauge & the sender that have to match....Joe