Topics

16

General Discussion / Suspension woes

« on: June 30, 2018, 10:02:47 PM »

I just realized my upper control arm retainer washer and bolt are missing , darn thing just came loose and fell out. Any of the members know where I can locate an original bolt and washer? It's for a 69 Camaro.

17

General Discussion / team camaro

« on: February 10, 2018, 05:53:28 PM »

Forgot my password over at the Team Camaro site and can't figure out how to reteive it . Does anyone know how to get in touch with the administrator of this site directly ?

18

General Discussion / spark plugs

« on: September 26, 2016, 01:38:26 AM »

I would like to put a fresh set of spark plugs in my 1969 Z28, it has the original 302 in it , what would you guys recommend using? I drive the car around on weekends and don't really need a set of n.o.s. plugs in it.

19

General Discussion / 1969 Muncie M21

« on: August 02, 2016, 11:37:26 PM »

What fluid would you guys recommend to use in my Muncie M21 Transmission ? I've had the trans rebuilt (twice) and after both rebuilds I am having the same shifting issues ( upshifting from 2nd to 3rd ). I'm thinking I might have the wrong fluid in it which is casing the hard shifting problems.

20

General Discussion / CV fan clutch

« on: March 04, 2015, 11:43:01 PM »

I'm just being curious but I wanted to know what a 1969 Z28 Camaro CV fan clutch sells for ?

21

Originality / 1969 Muncie Transmission

« on: March 03, 2015, 10:06:38 PM »

When did they start using bolts ( instead of using nuts ) to attach shifter rod levers on a 1969 Muncie transmission ? The transmission is a 660 main case and has a 306 side cover.

22

Originality / 1969 camaro door mirror

« on: February 24, 2015, 09:04:19 PM »

Does anyone know what the correct part number  for a late September Camaro drivers side door mirror?

23

Restoration / YH rims

« on: January 26, 2015, 12:52:11 AM »

I'm restoring some YH rims and have a concern about the area where the sides of the tire meet the edge's of the steel rim. The area is pitted and I'm not sure if this will seal properly. If rims are pitted can't tire shops use a sealer for just this situation ?

24

Originality / 1969 camaro Z28 Shifter rods

« on: January 13, 2015, 11:04:27 PM »

I recently took out my shifter rods and noticed  my levers were stamped 5615 on both rods. I looked up those numbers and they were installed on 1970-72 Camaro Z28,s .My Z28 is a early September built car. Would it be possible that the 5615 rods and levers were used on my car since it was such a late built car ?

25

Restoration / 69 camaro trim rings

« on: January 06, 2015, 01:12:24 AM »

I am looking to replace the trim rings on my 1969 Camaro Z28.  Don't really need originals (I'm just too hard on them) Who sells good reproduction rings?

26

Restoration / restoring YH rims

« on: January 01, 2015, 10:49:50 PM »

I'm restoring some YH rally rims for my Camaro this winter, after sandblasting I noticed a couple of the rims are pitted from rust . What's the best way to go about repairing those areas that are pitted ?

27

1969 - Orphans / 19N642693 M21 Muncie Transmission

« on: December 26, 2014, 08:34:54 PM »

I have a M21 Muncie Transmission that has the vin. no. 19N642693 and is stamped P9D25B. Would like to find the car it came from.

28

Originality / YH Ralley Rims

« on: December 26, 2014, 02:34:34 PM »

I want to pick up the paint for my ralley rims that I'm going to paint. I'm not sure about the finishes, should the back be a semi gloss Black and the front a semi-gloss Argent Silver ?

29

General Discussion / 1969 z28 coil wire terminal

« on: November 22, 2014, 10:57:49 PM »

I noticed that my coil wire terminal is bad on my 69 Z28. Where can I find an original wire terminal. It's in the shape of the letter F and has two wires connected to it.

30

General Discussion / 1969 camaro windshield washer pump

« on: October 23, 2014, 12:09:52 AM »

After years of not having a working windshield washer pump (my piston seal was worn out) I finally got it working again ! iI wanted to rebuild my original pump and there is no one that sells a complete rebuild kit for this pump, the only rebuildalbe part that is sold is the tri-port o-ring seal. I ended up buying an Anco pump from RockAuto ($30.88), took apart the pump, removed the new piston and used it in my original pump. My pump works like brand new !